Innovation House pulls up limp

 

[update: power fully restored on 11/14, 3D printer working on shorter jobs--haven't fully investigated the problem on long jobs yet]

I sent the following e-mail out to all registered users of IH today:

We are having a couple of issues at Innovation House that I need to notify you about.
1. There seems to a partial power outage. This is affecting the outlets in and near the closet. Unfortunately this includes all network capabilities (including the dropcam). I put in a call to facilities to work on it (after I checked the breakers of course).
2. The makerbot 3D printer is giving thermal shutdown faults on long print jobs. We have started working with Makerbot to sort this out. I tried a 20 minute print and it was fine. Anything over a hour may not finish until we get this fixed.
I will send another e-mail when these problems have been resolved.
Bill Ball

Things happen and I hope to have a 100% operational death star again soon.

 

 

Leave a Reply